Personal workspaceFizzlayer
Workspace Agents
Personal workspace

AGENTS + DEVICES

Agents

Let AI agents read your sensors, and pair new devices.

01 / CONNECT AN AGENT

Give an agent access

Hermes, Claude Code, and other MCP clients connect to Fizzlayer with their own token. Agents can read sensors and readings, and claim device pairing codes. They never see device keys or your phone number. Setup guide

MCP endpoint

02 / CONNECTED

Your agents

    PAIR A DEVICE

    Pair a device

    Connect a Raspberry Pi or Linux computer as a live sensor. Enter the code from fizz pair below, then approve the connection in your device terminal.

    How to install the CLI and add a device
    1. Install the CLI on your device

      Open a terminal on your Raspberry Pi or Linux computer and run:

    2. Get a pairing code

      Run this command on the same device. Keep the terminal open.

      Enter the code below. Codes expire after 15 minutes.

    3. Pair and approve

      Submit the code here, then return to the device terminal. Check the account name and approve the request to finish connecting. You can also ask a connected agent to claim the code.

    4. Start sending readings

      After approval, run this on your device to stream CPU temperature, load, memory, and disk usage where available:

      fizz run --every 60

      Your device appears as a Custom sensor on the Sensors page. Keep the command running to send a reading every minute. fizz run --stream --every 15 keeps one WebSocket open, fizz send --mqtt publishes MQTT, and fizz tail prints live readings. Those commands read addresses from GET /api/stream. Hosted MQTT is WebSocket only; there is no TCP port 1883.

    Using an ESP32 or another microcontroller? Create a sensor on the Sensors page and choose Connect API to send readings with its own key. To connect a phone, add a Phone sensor and choose Create phone link.